99
Turn ON the power supply.
<Preparation of the remote controller>
(1) While pressing both
OPERATION SELECT
button and
Too Cold
button on remote controller at the
same time, press
RESET
button.
(2) First, release
RESET
button. Hold down the other two buttons for another 3 seconds. Make sure
that the indicators on the LCD screen shown in the right figure are all displayed. Then release the
buttons.
(3) The set temperature is displayed to 24°C
(4) Press
STOP/OPERATE (OFF/ON)
button of the remote controller (the set temperature is displayed)
with the remote controller headed towards the indoor unit.
Turn ON the power supply.
<Preparation of the remote controller>
(1) While pressing both
OPERATION SELECT
button and
Too Cold
button on remote controller at the
same time, press
RESET
button.
(2) First, release
RESET
button. Hold down the other two buttons for another 3 seconds. Make sure
that the indicators on the LCD screen shown in the right figure are all displayed. Then release the
buttons.
(3) The set temperature is displayed to 24°C
(4) Press
STOP/OPERATE (OFF/ON)
button of the remote controller (the set temperature is displayed)
with the remote controller headed towards the indoor unit.
Turn ON the power supply.
<Preparation of the remote controller>
(1) While pressing both
OPERATION SELECT
button and
TEMP +
button on remote controller at the
same time, press
RESET
button.
(2) First, release
RESET
button. Hold down the other two buttons for another 3 seconds. Make sure
that the indicators on the LCD screen shown in the right figure are all displayed. Then release the
buttons.
(3) The set temperature is displayed to 24°C
(4) Press
STOP/OPERATE (OFF/ON)
button of the remote controller (the set temperature is displayed)
with the remote controller headed towards the indoor unit.
Turn ON the power supply.
<Preparation of the remote controller>
(1) While pressing both
OPERATION SELECT
button and
TEMP +
button on remote controller at the
same time, press
RESET
button.
(2) First, release
RESET
button. Hold down the other two buttons for another 3 seconds. Make sure
that the indicators on the LCD screen shown in the right figure are all displayed. Then release the
buttons.
(3) The set temperature is displayed to 24°C
(4) Press
STOP/OPERATE (OFF/ON)
button of the remote controller (the set temperature is displayed)
with the remote controller headed towards the indoor unit.
MSZ-LN / MSZ-EF / MSZ-AP / MSZ-BT
MSZ-HR / MSZ-HJ
MSZ-LN / MSZ-EF / MSZ-AP / MSZ-BT
MSZ-HR / MSZ-HJ
FAILURE MODE RECALL M SERIES
- INDOOR UNIT - MONOSPLIT
FAILURE MODE RECALL M SERIES
- OUTDOOR UNIT - MONOSPLIT
MITSUBISHI ELECTRIC
/ DIAGNOSTIC
Содержание M-SERIES
