Mitsubishi Electric Lancer Evolution-VII, Руководство по ремонту

Страница: 1357 / 1449

ENGINE OVERHAUL -
Specifications
11B-8
SEALANTS
Item Specified sealant Quantity
Engine support bracket bolt 3M
TM
AAD Part No. 8672 or equivalent As required
Semi-circular packing 3M
TM
AAD Part No. 8672 or equivalent As required
Rocker cover 3M
TM
AAD Part No. 8672 or equivalent As required
Water outlet fitting Mitsubishi Genuine Part No. MD970389 or
equivalent
As required
Engine coolant temperature gauge unit 3M
TM
AAD Part No. 8672 or equivalent As required
Engine coolant temperature sensor 3M
TM
AAD Part No. 8672 or equivalent As required
Cylinder head (camshaft bearing cap mounting
section)
3M
TM
AAD Part No. 8672 or equivalent As required
Cam position sensor support Mitsubishi Genuine Part No. MD970389 or
equivalent
As required
Oil pressure switch 3M
TM
AAD Part No. 8672 or equivalent As required
Oil pan Mitsubishi Genuine Part No. MD970389 or
equivalent
As required
Oil seal case Mitsubishi Genuine Part No. MD970389 or
equivalent
As required
FORM-IN-PLACE-GASKET
FIPG is used for several members of this engine. With this gasket, caution is required to the application
amount, application procedure and state of the application surface so that the performance is sufficiently
attained.
If sufficient gasket is not applied, leaks could occur, and if too much is applied, the gasket could protrude
and plug or restrict the oil and water flow passage. Thus, to prevent leaks from the joined sections,
it is absolutely necessary to evenly apply the correct amount.
The FIPG used for the engine parts reacts with moisture in the air and hardens so use it for the normal
metal flange parts.
DISASSEMBLY
The parts assembled with FIPG can be easily disassembled without special means. However, in some
cases, the sealant on the seams must be broken by lightly tapping with a wood hammer or similar tool.
A smooth and thin gasket scraper can be lightly tapped into the seams but in this case, take care not
to damage the seams.
The special tool oil pan remover (MD998727) is set for this purpose.
WASHING THE GASKET SURFACE
Completely remove all matters adhered on the gasket surfaces with a gasket scraper or wire brush.
Confirm that the FIPG application surface is smooth. There must be no grease or foreign matter on
the gasket surface.
Always remove the old FIPG that has entered the mounting holes and screw holes.
APPLICATION PROCEDURES
Apply an even coat of FIPG within the predetermined radius. Completely cover the areas around the
mounting holes. The FIPG can be wiped off if it has not hardened. Install at the set position while the
FIPG is still wet (within 15 minutes). When installing, maker sure that the FIPG does not get on areas
other than the required areas. After installing, do not subject the application areas to oil or water or
start the engine until the FIPG has sufficiently hardened (approx. one hour). The FIPG application procedures
differ according to the member, so follow the procedures given in this manual and apply the FIPG.