—17—
6
Remove the blower.
*Replace the packing of the disassembled part with a new
one.
* When replacing the packing, be careful not to twist it.
5
Remove the blower cover clamping screws (four PTT
screws 4 x 16, indicated by
●
).
* When installing the blower cover, be sure to securely inlay
the part indicated by .
* Once the blower cover is installed, slide the line filter
(indicated by
▲
) over the lead wires (red, white and
black) of the blower.
(6) Light emitting board (top)
1
Perform the same work as in step
1
of (2) above.
2
Remove the cover clamping screws for light emitting board
(top) (two PTT screws 4 x 16, indicated by
●
), and disconnect
the lead wires of the light emitting board.
(5) Blower
1
Perform the same work as in steps
1
through
8
of (4) above.
2
Remove the drain hose clamping screw (one PTT screw 4 x
16, indicated by
●
).
3
Remove the bushing (indicated by
▲
).
*When installing the bushing, be sure to securely inlay it all the
way to the base.
4
Remove the relay connector (indicated by
●
).
Содержание JT-SB216DS-W-AUS
