English
−
NA
-
5
−
−
NA
-
4
−
Cautions
•
Only use cleaning products that are labeled as safe "Safe to use on plastics".
•
Do not use any of the following cleaning materials.
(They may damage the surface of the unit, or cause discoloration or cracking.)
•
Solvents such as thinner or benzene
•
Acid, alkaline or chlorine detergents
•
Mold and mildew removers
•
Citrus
-
based or other plant
-
based detergents
•
Nylon scourers or abrasives
•
Antiseptics
•
Do not clean the front panel with alcohol.(Only JT
-
SB116JH2
-
S
-
NA)
(This may damage the surface of the unit, or cause discoloration or cracking.)
※
"Alcohol" means a disinfectant with an ethanol content of 83% or less.
※
Be sure to dispose of any alcohol that has collected in the drain tank.
※
Do not spray alcohol directly onto the unit.
Damage to the unit (such as rusting) is not covered by the warranty if the above cautions are not observed.
Hand drying area
Sensor
Front panel
Black wall area
－
4
－
•
When cleaning the unit, use a neutral detergent. (pH: 6
-
8)
•
The exterior of the unit can be wiped with alcohol. (Excluding the front panel)
•
After cleaning with neutral detergent or alcohol, be sure to wipe away all remaining traces of the detergent or alcohol.
•
After wiping the unit clean with alcohol, be sure to dispose of any alcohol that has collected in the drain tank.
※
Do not spray alcohol directly onto the unit.
•
When using a chemical cloth, be sure to follow the instructions carefully.
Warning
Caution
•
Always turn off the power during maintenance work.
Failure to do so may result in an electric shock.
•
Do not douse the unit with excessive amounts of water.
This may cause electric shocks or malfunctions.
•
Wear rubber gloves when cleaning the unit.
Not doing so may result in injuries.
Cleaning the unit and hand drying area
1
Maintenance
Wipe with a well
-
wrung wet cloth
NOTE
•
After cleaning with neutral detergent or alcohol,
be sure to wipe away all remaining traces of the
detergent or alcohol.
•
Clean the sensor area about once a week.
If it is particularly dirty (at least once a week)
NOTE
Cleaning the drain pipe
4
At least once a week
• Gently wipe any dirt from the drain using a soft cloth.
• Do not pour water directly onto the drain pipe.
NOTE
Cautions
• Ensure that the side cover is fitted properly.
Drain
collection
outlet
Drain pipe
4 After cleaning, attach the side cover.
－
6
－
Drain collection
outlet
Drain pipe
Handle
Drain hole
2 Hook your fi ngers into the handle on the
side cover, and pull it diagonally upwards
1 Turn the ground
-
fault circuit interrupter "OFF".
3 Wipe the inside of the side cover and
drain pipe with a well
-
wrung wet cloth
Side cover (inside)
