─
20
─
(8) Filter circuit board (JT-34F)
1
Unscrew the clamping screw, and remove the terminal block (TB)
cover.
(One PTT screw 4×6, indicated by
)
Ground wire
2
Unscrew the clamping screw, and disconnect the ground wire.
(One PT screw 4×8 BS, indicated by
)
3
Unscrew the TB fix plate clamping screw, and remove the terminal
block parts.
(One PTT screw 4×16, indicated by
)
TB fix plate
4
Unscrew the clamping screw, and remove the PCB cover.
(One PTT screw 4×6, indicated by
)
PCB cover
Assembly precaution
Install the PCB cover over the TB fix plate.
Precaution
Pay attention not to pull the ground wire, which is threaded through
the cord bush of the TB cover.
TB cover
Terminal block
5
Disconnect the lead wires from the filter circuit board.
6
Remove the spacers (four locations, indicated by
), and then re-
move the filter circuit board (JT-34F).
(Pinch the spacers from the back for easier removal.)
Filter circuit board (JT-34F)
Assembly precaution
Run the lead wires through the cord bushes. (Indicated by
)
TAB21
TAB20
