Mitsubishi Electric FR-E800, Инструкция по эксплуатации

Страница: 213 / 484

212
10. (D) Operation Command and Frequency Command
10.1 Operation mode selection
10
(D) Operation Command and Frequency
Command
10.1
Operation mode selection
Select the operation mode of the inverter.
The mode can be changed among operation using external signals (External operation), operation by the operation panel (PU
operation), combined operation of PU operation and External operation (External/PU combined operation), and Network
operation (via RS-485 communication or Ethernet communication, or when a communication option is used).
The following table lists valid and invalid commands in each operation mode.
Purpose Parameter to set
Refer to
page
To select the operation mode Operation mode selection P.D000 Pr.79 212
To start up the inverter in Network operation
mode at power-ON Communication startup
mode selection
P.D000, P.D001 Pr.79, Pr.340 222
To select the command source during
communication operation
Operation and speed
command sources during
communication operation,
command source
selection
P.D010 to P.D013
Pr.338, Pr.339, Pr.550,
Pr.551
223
To prevent the motor from rotating
reversely Reverse rotation
prevention selection
P.D020 Pr.78 231
To change the setting resolution of the
torque limit
Set resolution switchover P.D030 Pr.811 268
To perform JOG (inching) operation JOG operation P.D200, P.F002 Pr.15, Pr.16 232
To control the frequency with combinations
of terminals
Multi-speed operation P.D301 to P.D315
Pr.4 to Pr.6, Pr.24 to
Pr.27, Pr.232 to Pr.239
234
To select the torque command method
during torque control Torque command source
selection
P.D400 to P.D402 Pr.804 to Pr.806 143
Pr. Name Initial value Setting range Description
79
D000
Operation mode selection 0 0 to 4, 6, 7 Selects the operation mode.