Mitsubishi Electric DX-TL910U, Инструкция по установке и эксплуатации

Страница: 17 / 96

17
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Beginning
VIDEO
1
MAIN
OFF
ON
AC IN
~
2 3 4 5 6 7 8 9
1 4
RESET
RS-232C
2 3 5 6 7 8 9
1
ALARM IN
2 3 4 5 6 7 8 9
CLOCK ADJ REC EMERGENCY MODE OUT 1 MODE OUT 2 MODE OUT 3 MODE OUT 4 MODE OUT 5 CALL OUT CALL OUT GND MAX 350mA DC 12V OUT GND
CAMERA OUT
RS-232C
RESET
CAMERA IN
IN OUT
OUTPUT A
OUTPUT B
MIC
GND
AUDIO
100-240V
Y/C
LAN
RECEIVE SEND
12 13 11 10 9 8 7 6 5
1
2 3 4
This unit must be grounded at all times. Never
connect this unit to a power outlet which does not
have a ground terminal.
Please use the AC power cord accessory.
6. GND terminals
It is the common GND terminal.
7. AUDIO connectors
AUDIO IN connector
Input connector for audio signal (RCA pin).
AUDIO OUT connector
Output connector for audio signal (RCA pin).
8. MIC jack
Input connector for microphone (600 ohm imped-
ance). Use of MIC connector for audio recording has
priority over AUDIO IN connector.
9. RESET button
Pressing this button resets the unit and the power
turns off. In this case, video data, menu settings and
the current time are kept.
10. ALARM IN terminals
Input terminal for alarm signal.
11. I/O terminals
CLOCK ADJ terminal
Input terminal to set the present time. Time display is
adjusted to the nearest hour (00 minutes 00 seconds)
when this terminal receives the CLOCK ADJ signal.
INFORMATION
The on-screen clock can be reset to the nearest hour,
by applying a signal to the CLOCK ADJ terminal. For
example, if the current time is 11:29:59, it will be reset
to 11:00:00, and if the current time is 11:30:00, it will be
reset to 12:00:00.
1. MAIN switch
This is the main power switch. When using this unit,
set this switch to ON. Otherwise, the power cannot
be turned on using the POWER button on the front
of the unit.
2. VIDEO OUT connectors
OUTPUT A VIDEO connector
Output connector for video signal for monitor A (BNC
connector).
OUTPUT A S(Y/C) connector
Output connector for video signals that separate
brightness signals and color signals for higher pic-
ture quality. Simultaneous output along with OUT-
PUT A VIDEO is also possible.
OUTPUT B connector
Output connector for video signal for monitor B for
live image display only. (
see page 41). To dis-
play the image, set “OUTPUT B ON/OFF” on the
<MPX DISPLAY SETTINGS> screen to “ON”. The
playback image cannot be put out to the OUTPUT B
connector.
3. CAMERA IN connectors
Input connector for signal of camera (BNC connector).
4. CAMERA OUT connectors
Loop through output is supported for each input cam-
era. Each output is automatically self terminated if
not used.
5. AC power socket
This socket connects to the power cord. Earth ter-
minal is for safety. Use the 100 ~ 240V plug with
earth for the power of this unit.
■
Rear View