EN-6
2
3
1
What’s included in the box
AC power cord
1 RGB cable for PC
for US J55-006-0
for EU J55-0066-0
for UK J55-0065-0
J55-007-0
1 Remote control
1 User Manual/Quick Start up (English only)
1 Safety Manual/Quick Start up
1 CD-ROM (with User Manual)
Battery
1 Lens cap
1 Lamp replacement attachment
Important:
The attached power cords are to be used exclusively for this product. Never use them for other products.
•
Inserting the batteries into the remote control
Remove the back lid of the remote control.
Check the polarity (+), (-) of the batteries, and set them
correctly, inserting their (-) side first.
If the battery is inserted from the (+) side first, inserting
the (-) side is difficult because the coil spring end hits
on the battery side. If the battery is forced in this way,
the outer label of the battery may get ripped and it may
cause a short-circuit and heating.
Attach the back lid.
Important:
Use two size-AA batteries (R6).
Replace the two batteries with new ones when the
remote control is slow to respond.
Removing the batteries from the remote control
Remove the back lid of the remote control and take out the batteries.
Caution:
Use of a battery of wrong type may cause explosion.
Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.
Dispose of used batteries according to your local regulations.
Batteries may explode if misused. Do not recharge, disassemble, or throw them in fire.
Be sure to handle the batteries according to the instructions.
Load the batteries with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.
Keep batteries out of reach of children and pets.
Remove the batteries, if the remote control is not used for a long time.
Do not combine a new battery with an old one.
If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in
contact with your eyes, rinse them with water and then consult your doctor.
1.
.
•
.
•
•
•
•
•
•
•
•
•
•
•
•
Preparing your projector
