Mitsubishi Electric apricot VS660, Руководство по продукту системы

Страница: 50 / 154

System Product Guide
3-21
Exit Screen
This section describes the different ways to exit and save or not save changes
made in the Setup program.
Exit Saving Changes
Saves the changes to CMOS RAM and exits the Setup program. You can also
press the <F10> key anywhere in the Setup program to do this.
Exit Discarding Changes
Exits the Setup program without saving any changes. This means that any
changes made while in the Setup program are discarded and NOT SAVED.
Pressing the <Esc> key in any of the four main screens will do this.
Load Setup Defaults
Resets all of the setup options to their defaults. You can also press the <F5>
key anywhere in the Setup program to do this.
This selection loads the default Setup values from the ROM table.
Discard Changes
Discards any changes you made during the current Setup session without
exiting the program. You can also press the <F6> key anywhere in the Setup
program to do this.
This selection loads the CMOS RAM values that were present when the
system was turned on.
■
■
■
■
■
■