U p g r a d i n g
LS700 HANDBOOK 4/9
7.
When the SIMM seats correctly, hold it at each end
and gently push the top edge towards the retaining clips
of the connector until the SIMM snaps into place.
◊
If the SIMM does not install correctly, gently
spread the retaining clips just enough so that you
can pull away the top edge of the SIMM and try
again.
8.
Reinstall and reconnect any parts you removed or
disconnected to gain access to the SIMM sockets.
9.
Replace the computer cover.
Memory detection is mostly automatic, but if you get an
error message, check that:
♦
You have used a supported SIMM value.
♦
Both SIMMs in the bank are the same.
How to Remove Memory
To remove a SIMM, do the following:
1.
Observe the precautions in ‘Before You Begin’ (see
page 1 of chapter 2
).
2.
Turn off the computer and unplug the power cable.
3.
Remove the computer top and access covers.
4.
Gently spread the retaining clip at each end of the
SIMM socket, just enough to allow you to tilt the top
edge of the SIMM to an angle of about 45
°
.
5.
Holding the SIMM only by the edges, lift it away from
the socket, and store it in an antistatic package.
6.
Reinstall and reconnect any parts you removed or
disconnected to gain access to the SIMM sockets.
7.
Replace the computer covers.
