T r o u b l e s h o o t i n g
6/6 LS700 HANDBOOK
Error Messages
Some of these messages may indicate a serious fault with the
system and may cause the POST to halt. If the message
persists, make a note of it and call your supplier or
authorised maintainer.
PCI Configuration Error Messages
The following PCI messages are displayed as a group with
bus, device and function information.
Message
Explanation
Bad PnP Serial ID Checksum
The Serial ID checksum of a Plug and Play
card was invalid.
Floppy Disk Controller Resource
Conflict
The floppy disk controller has requested a
resource that is already in use.
NVRAM Checksum Error,
NVRAM Cleared
The ESCD data was reinitialized because of an
NVRAM checksum error. Try rerunning the
ICU.
NVRAM Cleared By Jumper
The “CMOS Clear” jumper has been moved
to the “Clear” position and CMOS RAM has
been cleared.
NVRAM Data Invalid, NVRAM
Cleared
Invalid entry in the ESCD.
Parallel Port Resource Conflict
The parallel port has requested a resource that
is already in use.
PCI Error Log is Full
This message is displayed when more than 15
PCI conflict errors are detected. No additional
PCI errors can be logged.
PCI I/O Port Conflict
Two devices requested the same resource,
resulting in a conflict.
PCI IRQ Conflict
Two devices requested the same resource,
resulting in a conflict.
