CS62 / CS64 SELECT Chainsaw
18
Original Instructions Version July 16
CS62-64_130716
Hot Engine Start
1.
Set the switch (3) to “I” position.
2.
Pull out the choke knob (5), then push the choke knob back in, this will set the choke to
the hot start position.
3.
Push in the decompressor valve (6).
4.
Apply the chain brake (7) by pushing the chain brake forwards.
5.
Pull the starter handle until the engine runs.
6.
As soon as the engine is running, pull the throttle lever slightly to reset the throttle control
to idle. This must be done as soon as the engine has started to avoid unneccessary wear
on the clutch.
NOTE: Disengage the chain brake by pulling the chain brake
towards the front handle prior to cutting.
Running In
During the first ten hours of work, avoid running the engine at maximum speed for a prolonged
period until all the components have bedded in. After the engine has been run in, it will reach its
maximum power. After two hours of work, check that all nuts and screws are securely fastened and
tighten if necessary.
Stopping the Engine
1.
Release the throttle lever and allow the engine to run at idle for half a minute.
2.
Set the ignition switch to the STOP position (“0”).
NOTE: Except for an emergency, avoid stopping the engine while at full throttle.
6
Содержание CS62 Select
