Operation | 14
1/3 Rack Block Downconverters (Option 17)
DNB1-XTR, Rev.N, 8/14/2012
®
REDUNDANT SERIAL PORT REMOTE OPERATION SCREEN
Figure 3-8. Redundant Serial Port Remote Operation Screen Display
The redundant serial port is always con
fi
gured for RS485 (two-wire) operation and cannot be changed.
Redundant Serial Port Address
Units can occupy a remote address from 64 to 95 decimal.
To select the remote address for the redundant serial port:
•
Use the up and down arrow keys to access the Redundant Serial Port Remote Operation screen.
•
Press the left or right arrow key to select the address
fi
eld “ADD” on the display.
•
Use the up and down arrow keys to increment or decrement the displayed address respectively.
•
Press “ENT” to save the address.
Redundant Serial Port Baud Rate
To select the baud rate of the redundant serial port:
•
From the Redundant Serial Port screen, use the left or right arrow key to select the baud rate
fi
eld “BAUD” on the
display.
•
Use the up and down arrow keys to scroll through the available options until the desired setting is displayed. The
baud rates available are 2400, 4800, 9600 and 19200.
•
Press “ENT” to save the selection.
Redundant Serial Port Parity
To select the parity for the redundant serial port:
•
From the Redundant Serial Port screen, use the left or right arrow key to select the parity
fi
eld on the display.
•
Use the up and down arrow keys to scroll through the available options until the desired setting is displayed. The
parity can be set to “ODD”, “EVEN” or “NONE”.
•
Press “ENT” to save the selection.
ETHERNET PORT REMOTE OPERATION SCREENS
If not already displayed, use the up and down arrow keys to access the Ethernet Port Remote Operation Screen. The
Ethernet Port Remote Operation Screens allow the operator to con
fi
gure the Ethernet settings listed below. They are
presented in four consecutive screens:
•
IP Address
•
Subnet Mask
•
Gateway
•
Password
