Mitel 3300, Руководство техника

Страница: 152 / 431

142
3300 ICP Technician’s Handbook
Assign Static IP Addresses to IP Phones
The customer may prefer to assign static IP addresses to IP sets rather
than using dynamic IP addressing. You cannot set static IP addresses on
non-display sets.
Setting Static IP Addresses on Dual Mode Sets
On the 5215 IP Phone (Dual Mode), press * (yes), 0 (default), and # (no);
on the 5220 IP Phone (Dual Mode), press the three softkeys to select
menu items.
Accessing the Configuration Menu
Method A: To access the menu during the phone boot sequence:
• Hold down both volume keys until NETWORK PARAMETERS?
appears.
Method B: If the phone is up and running with the MiNet main load:
1. Hold down both volume keys at the same time.
2. Continue to hold the down volume key and release the up volume key.
3. Press 234 on the telephone key pad and then release the down key.
- NETWORK PARAMETERS? appears.
4. Proceed to “Viewing and modifying the static IP address:” on
page 143.
Method C: Using hotkeys, at power up, press and hold the following key
combinations:
Table 18: Accessing the Configuration Menu: Method C
Key Sequence Function
* and 6 (M) Change mode to MiNet
* and 7 (S) Change mode to SIP
7 Jump to “Config Teleworker” menu
* Erase the PIN and VCON configuration
any other keypad keys Display “Configure Phone” prompt
Note: Hotkeys access provides limited access. Methods A and B provide full
access