Garden/Tower-MICRO Use and installation manual Page 16 of 20
WARNINGS
1. When carrying out the work for preparing the detector for use as well as in using it, the current
rules on technical safety have to be observed in the use of electric installations.
2. The emission level of the TU of the detector, in accordance with the effective norms for personal
safety of those, who are professionally, allows non-stop working.
To guarantee the maximum reliability of the sensor operation, the horizontal distance between the
DZ axis and the edge of the exclusion zone must be:
- at least 1.2m for a section up to 50m long
- at least 1.5m for a section between 50m and 100m long
3. In the exclusion zone the maximum height of the unevenness of the ground and the snow and
grass cover shall not exceed 0.3 m
The use of the sensor is admitted when the snow or grass cover exceeds the stated value.
However the sensor might not pick up a person that is moving on the snow or grass. In this
case the unit height must be modified. If the above requirements are not complied with, the
characteristics of the device might be altered.
4. If the maximum level of the signal received is reached during the adjustment, when the units are
directed towards reflective surfaces (fences, ground, etc.), it is necessary to change the position
and orientation of the aerials.
5. A possible cause for the false alarms of the device might be the RU unit receiving the emissions of
different Tus.
6. Carry out testing for no less than 3 days and check the crossing sensing at least twice in 24 hours.
7.
The device works properly and does not give false alarms even in the event of disturbances
caused by:
a) the movement of a person at the following distances from the DZ axis:
- 1.5m in length on a 50m surface;
- 2.0m in length on a 100m surface;
b) the movement in the DZ of small animals (birds) at a distance greater than 3m from the TU or
RU units.
General characteristics
GARDEN/TOWER MICRO
Max. operating range outdoors
100 m (200 m on request)
Min. operating range outdoors
5 m
Column height
1,5 m – 2,0 m - 2,5 m – 3,0 m
Power-supply
12Vdc – recommended 13,8 Vdc
Maximum absorption
570 mA (TX 200 mA – RX 370 mA)
model column by 3 meters in height
Operating temperature
–35°C +70°C
Vertical alignment angle
30°
Horizontal alignment angle
180°
Detection system
AND / OR on Tx and Rx AND remote
Alarm output
Contact of exchange relay NC/NA
Tamper output
NC contact
MW signal
High frequency electromagnetic waves
Lobe height
2,5 m
Lobe opening
1,0 m
Serial communication
RS485
MW alignment
Manual
LED indicators
Power supply, blinding, heating, low signal,
alarm, detection
MW LED warning
Alarm
Class of protection
IP 65
Full warranty 2 years
