Mistral MCCT25SS, Руководство пользователя

Страница: 8 / 32

8
Operation of Air Conditioner
• Operation procedure using the remote control
Operation modes
• If the unit does not respond when changing modes during operation, wait 3 minutes and try
again.
• When heating mode is selected the unit will not discharge the airfl ow until the indoor heater
exchange temperature has risen suffi ciently, approximately after 2.5 minutes.
• Wait 3 minutes before restarting the unit.
Each time the MODE button is pressed, the operation mode
is changed in sequence:
Press until your desired mode appears.
Each time the "FAN" button is pressed, the fan speed is
changed in sequence:
"I FEEL "mode is specified on page 9.
The compressor does not run in "FAN ONLY " mode.
18 ~32
HEATING
"I FEEL" COOLING DRY
FAN ONLY
��������������
����������������
2
+
-
AUTO
HI MED LO
.
At "FAN ONLY" mode, only "HI","MED" and "LO" are available.
When in DRY mode the airflow is set by the Air conditioner
automatically, the FAN button is ineffective in this mode.
�������������������
Press once to lower temperature by 1
Press once to raise temperature by 1
Range of available set temperature
������������������
���
���
unable to set
room temperature
����������
To turn on the unit press the ON/OFF button, a beep
indicates the signal is received from the remote control
and the RUN indicator will light up.
�
�
�
�
���
������
����
����� ����� ����
��� ��� �����
������
�����