Menu
9
To access additional controls over the LX CONNECT system either press 'MENU' on your remote or touch the MENU
button on the front panel of the hub. This will give you different options: Speakers, Mode, Digital Filter, DSD BW, DPLL
BW, Balance, Pre Delay, Brightness, Default Channel, Auto Standby, Wireless, Pre Out Level, Default Volume, Factory
Reset, Update and Firmware. You can toggle through the different options by pressing the '+' or '-' controls on the hub
or left and right controls on the remote. The source button on hub toggles between menu select and the menu
parameter, or you can press the VOL+/VOL+ button on the remote. When you have selected a parameter to adjust,
press the '+'or'-' buttons on the hub, or left and right controls on the remote.
There are two performance modes for the LX CONNECT system:
Music (recommended for listening to music),
Movie (recommended for viewing movies).
Mode
Mode
Music
Mode
Movie
The DAC in the LX CONNECT has a choice of 3 digital filters to offer the best
performance and compatibility with your digital audio files and system:
Fast roll off: Standard flat response with fast frequency roll of above Fs/2
(half the sampling frequency).
Slow roll off: Starts rolling of at a lower frequency than the Fast filter but has
a more gentle rate of attenuation. This is the default filter for the LX
CONNECT Hub.
Minimum phase: Has a gentle attenuation slope similar to the Slow filter but
with minimum phase characteristics. It can be likened to an analogue filter
applied in the digital domain.
Digital Filter (DAC, Only for Pre Out)
Digital Filter
slowrolloff
Digital Filter
Minimumphase
Digital Filter
fastrolloff
The DSD Bandwidth can be widened to suit high performance Hi-Fi
equipment and particular DSD audio files.
DSD BW
DSD BW
Normal
OPT DPLL BW
Normal
OPT DPLL BW
Wide
DSD BW
50K
DSD BW
60K
DSD BW
70K
DPLL setting is used for changing the bandwidth of the digital phase lock
loop of the D/A converter to accommodate different levels of jitter on the
incoming SPDIF signal.
Normal mode should be selected for signals with low jitter, while Wide mode
should be selected for signals with abnormal jitter. For best audio quality
leave this setting at the default value Normal, only use Wide for a given input
if the system is having problems locking onto the source.
OPT DPLL BW
Balance
3.0dB
L+
-R
Balance
3.0dB
L+
-R
Balance
0.0dB
L
R
Balance of left and right channels can be adjusted in the hub's menu. The
setting is for all the speakers and Pre Out. The Balance setting ON/OFF can be
controlled by the BALANCE SYNC button on the rear panel of each speaker.
Balance
Pre Out delay time setting have 0ms, 20ms, 40ms, 60ms, 80ms and 100ms. If
the Pre Out to be used for a wired and powered subwoofer, please use 20ms
to sync with the wireless speakers to get the best performance.
Pre Delay
PreDelay
0 ms
PreDelay
20ms (sub)
The brightness can be adjusted from a low level to a bright level, adjustable in
8 increments.
Brightness
Brightness
Level1
Brightness
Level8
