Miscea Light CCR1S1NCDE, Инструкция по эксплуатации

Страница: 32 / 84

32
10. Service
WATER RELATED PROBLEMS
Symptoms Experienced
Possible Problem or Cause Solution
• The water runs after connect-
ing to the power supply The system begins the calibration
process and dispenses water
immediately after connecting the
system to the power supply.
There is an issue with the solenoid
valve located inside the faucet. Please wait until the system has
calibrated and the water stops.
This should not take longer than 30
seconds.
Disconnect the miscea system
from the power point. After 10 sec-
onds, reconnect the miscea system
to the power point. This should
reset the system and resolve any
minor system glitches.
If the problem persists, please
contact miscea GmbH for further
technical assistance.
• The faucet is not dispensing
hot water.
• The faucet is not dispensing
cold water.
• Only one water temperature
is dispensed. Not able to
change water to hot or cold.
It is not possible to change the
temperature on the miscea LIGHT
unless an additional thermostatic
valve is used. Install an additional thermostatic
valve (miscea article number
S02032001) to be able to adjust
the water temperature.
If the problem persists, please
contact miscea GmbH for further
technical assistance.
• The faucet is not dispensing
water. The system is not plugged into a
working power point.
The mains water supply is not set
to open.
The shut off valve (if available) is
not set to open.
Check the system is plugged into a
working power point and switched
on.
Check the mains water supply is
set to open.
Check the shut off valve (if avail -
able) is set to open.
Check all cable and tubing con-
nections for loose connections or
incorrect connections. Please refer
to the relevant pages of manual for
correct installation procedure.
An issue with one or more of the
components in the faucet. Disconnect the miscea system
from the power point. After 10 sec-
onds, reconnect the miscea system
to the power point. This should
reset the system and resolve any
minor system glitches.
If the problem persists, please
contact miscea GmbH for further
technical assistance.