Toilet Tunes
™
LG Home Products, LLC
PO Box 4345
Hallandale, Florida, 33008
305 428-2599
www.LGhomeproducts.com
INSTRUCTIONS
STEP A: Setting wireless channel (A,B or C) and inserting
batteries:
1. Sensor.
Unscrew the battery door and open. On the left hand side you will see
a small black channel selection switch. It should be factory preset to channel A.
If it is not, use a small screwdriver or ballpoint pen to move it to channel A.
Insert 3 AAA batteries.
Close the lid and screw tightly shut to ensure a
waterproof seal.
-2-
2. Digital Sound Machine.
Turn the unit up-side-down and
remove the battery cover. In the
center
of
the
battery
compartment you will see a
black channel selection switch.
It should be factory pre-set to
channel A. If it is not, move it to
channel A.
NOTE: The small sensor and
the digital sound machine,
must always be on matching
wireless channels. A+A or
B+B or C+C
Channels of the Sound Machine and the Sensor must be the same or the unit
will not function in auto mode.
Now insert 4 size C batteries, close the lid and
place the unit on a flat, dry surface in the bathroom.
BE SURE TO KEEP THE UNIT OFF. You can test this by moving the round
volume wheel unit the unit "clicks" OFF.
STEP B: Install the Sensor under your Toilet's lid.
NOTE: PAY ATTENTION!
The sensor must be installed correctly for the unit to
function properly. The sensor must be installed UNDER the toilet lid, in a level
position, with the screw at the top when the lid is raised. LOOK at these pictures
carefully.
1.
Raise the
SEAT and
the LID
of your toilet. (The
TT
sensor
should
be
installed on the lid with
both
the seat and lid up to
be sure it will not hit the
seat when they are both
down)
2.
Locate where you want
to install the TT sensor. It
should be in the middle, a
bit below center on the
underside of the toilet lid.
Mark lightly with a pencil. Remember the screw goes UP and the unit
should be level!
