MISA OPTION CloudGate, Техническая документация инструкция

Страница: 29 / 218

26 / 215
Option CloudGate - Last updated on 14/05/2014
Installing Expansion Cards
CloudGate expansion cards are easy to install either during staging by a distributor or system integrator,
or in the field by a technician.
Expansion cards are designed to fit in one of two expansion slots accessed from the unit’s front or back
panels. In general, cards with antenna interfaces, such as the WLAN card, are installed in the back slot
to avoid interferance with the 3G antennas on the front of the base unit.
TIP:
TIP:
Another way to determine the appropriate slot, is to look at the card connector. Cards with
Another way to determine the appropriate slot, is to look at the card connector. Cards with
the small connector are installed in the rear slot. Cards with the large connector are installed in
the small connector are installed in the rear slot. Cards with the large connector are installed in
the front slot.
the front slot.
To install an expansion card:
Make sure the unit is powered off. 1.
Using a T6 Torx screwdriver, remove the three screws from the bottom plate on the front or back 2.
panel, and remove the plate.
With the expansion card in your hand, make sure the English labelling for any external interfaces,
3.
such WLAN Antenna or Serial Port, are facing up. In this orientation, the card connector is also right
facing.
Slide the card into slot, using the side channels or grooves on the device to guide the card into
4.
place. Make sure the screw holes line up.
Push gently until the card is flush with the housing. 5.
Secure the card with the screws. 6.
The following table lists the expansion cards available from Option and the slot.