![background image](http://html1.mh-extra.com/html/mircom/flex-net-fx-2003-12nds/flex-net-fx-2003-12nds_installation-and-operation-manual_1805816031.webp)
FleX-Net
TM
Installation and Operation Manual
29
FNC- 2000 Fire Netw ork Controller Module
An FNC-2000 Fire Network Controller module is required in each fire alarm node in the system. The FNC-2000 also
provides a connection for an optional FOM-2000-UM Fiber Optics Module.
Figure 11: FNC- 2000 Fire Netw ork Controller Module
Table 1: FNC-2000 Module List of Connectors and Jumpers and Functions
CONNECTOR
OR JUMPERS
Function
P8
P8
is for Factory Use Only.
P10
P10
connects to
P1
of the FOM-2000-UM Fiber Optic Network Adder Module if used.
JW1, JW2, JW4,
JW7, JW8, JW11
Jumpers for
JW1
,
JW4
,
JW7
, and
JW10
equal Line Termination (always short).
Jumpers for
JW2
and
JW8
equal Ground Fault (always short).
JW5 and JW11
Leave both un-installed. Do not connect JW5 or JW11 (open)
JW3, JW6, JW9,
JW12
Jumpers for
JW3
,
JW6
,
JW9
,
JW12
shall be present between pins 1 and 2 (far right) and
remain as is.
Note:
Network connection is through twisted cable from Line A, B, C and D. Refer to Figure 35 for specific
wiring and cable information.
This cable
connects to
P19 on the
Main Fire Alarm
Board
P8