10.0 System Configuration
24
10.0 System Configuration
10.1 Introduction To Configuration
Configuration of the BPS-1100 is performed by a combination of Configuration DIP Switch settings and button
presses. Circuit (Zone) related operations are correlated to their respective Disconnect Switches.
The Configuration DIP Switches are accessible from the Main Display Module after removing a protective Lexan
cover with two screws, and are labeled as CONFIG. 1 to 8. The Circuit (Zone) Disconnect Switches are re-defined
as Circuit (Zone) Select during Configuration. Caution should be used to reset the Zone Disconnect Switches back
to the desired settings before exiting configuration mode. Normal system operation is suspended while
Configuration Mode is active. Configuration Mode is entered whenever any of the Configuration DIP Switches are
set as per functions listed in the Configuration DIP Switch Function Table and exited by turning them all OFF (put
switches in the bottom or OFF positions), then performing a RESET.
Two buttons and LED indicators are used in Configuration Mode.
Select
This is a “Select Setting” button and the LED indicator may show current status of a function.
Confirm
This is a “Confirmation” button for some functions, used together with the Select button.
Figure 16 below shows the positions of the Configuration DIP Switch and the Select and Confirm Buttons.
Configuration Functions
are selected by the Configuration DIP Switches. as shown on
Switch Function Table on page 25
Figure 16: Configuration Indicators and Controls
While in Configuration Mode the BPS-1100 Is Not Operating!
All other buttons are non-functional during Configuration Mode.
Note:
A Switch position of “0" is “OFF” (bottom position) and “1" is “ON” (top position).
