Mircom BPS-1100, Инструкция по установке и эксплуатации

Страница: 16 / 44

6.0 Module Settings
10
6.2 Main Display Module (Part of Main Chassis)
P1 Cable connects to P3 of Main Chassis Board of the BPS-1100.
SW1 Dip Switch used for configuration of input and output circuits.
SW2, SW4, SW5 Dip Switches used for output circuit disconnect (labelled O/P Zone Disconnect). See 10.0
System Configuration on page 24.
SW3 Dip Switch used for input circuit disconnect (labelled I/P Zone Disconnect). See 10.0 System
Configuration on page 24.
The Main Display Module provides 4 dedicated Display Points for the 4 Indicating Circuits on the Main BPS-1100
Module. It also provides the following general purpose Display Points.
Chassis Type Display Points
MCC-1100-12 There are 4 Display Points dedicated to the 4 Main Board Indicating Circuits. The next 4 are
dedicated to the 4 Main Board Input Circuits and the next 16 for the Adder Indicating.
Figure 6: Main Display Module (For Service Personnel)
CONFIG.
O/P ZONE
DISCONNECT
I/P ZONE
DISCONNECT
O/P ZONE
DISCONNECT
O/P ZONE
DISCONNECT