Miranda NV9602, Руководство пользователя, Страница: 18 / 68

8 Rev 1.0 • 18 Aug 10
3. Installation
Installation
Installation
Follow these steps to install a NV9602 control panel:
1 Mount, and secure, the panel in the rack.
The NV9602 is designed to mount in a standard 19
″
rack. Rack-mounting is not a requirement.
2 We assume that you have an Ethernet switch connected to the “Panel and Router Network” port
of your system controller. Connect an Ethernet cable from that switch to the RJ-45 port at the
rear of the NV9602.
3 Connect power.
Installing Software and Documentation
This document is available through the Miranda web site.
You must use NV9000-SE Utilities to configure the NV9602 control panel. Contact Miranda if you
need to obtain the latest version of this NV9000 configuration software.
You may use the Panel IP Configuration Utility if you want to your NV9602 to have a static IP
address (with respect to the NV9000) or to use DHCP. The panel, as it comes from the factory,
defaults to DHCP.
Initialization
Before your NV9000 system controller can communicate with an NV9602, you must give it a panel
ID. Follow these steps for each NV9602 you are installing:
1 Power up the NV9602. Do not connect its Ethernet cable. (Disconnect it if it is connected.)
After a few seconds, the display will show ‘ACQ IP’ at the top and show the panel’s current
panel ID. The top right button is high-tally green:
We call that the “setup” button while the panel is disconnected from the network.
2 Press the setup button. The panel now allows you to enter the panel ID using buttons at the left
that function as a numeric keypad. The numbers of the keypad a printed on the panel. They
range from 0 (at the left) to 9:
Enter the panel ID using the keypad. Then press the setup button again.
A C Q I P
0
P a n e l I D
_ _ _ _ _ 1 2 3