Miranda Kaleido-X, Руководство по установке

Страница: 13 / 43

7
Kaleido-X (4RU)
Hardware Description & Installation Manual
3 Pull on the bracket holding the fastener; it rotates down and becomes a handle for
pulling the power supply out of its slot.
Installing a Power Supply
To install a power supply
1 Position the supply in front of an empty power supply slot in the top front of the frame,
with the connector end towards the frame.
2 Slide the power supply into the empty slot, moving it gently until it contacts the
sockets at the rear of the slot.
3 Push firmly but gently on the power supply faceplate until the power supply's
connectors have mated with the frame's sockets, and the power supply will go in no
further.
4 Use the captive screw in the rotating handle to secure the power supply in position.
Operation
Separate AC connectors are provided for the two power supplies, and are located at the
bottom left of the rear of the frame as seen from the rear. Connect both power supplies to
an appropriate power source using the supplied power cords.
• The top power socket is for PSU A.
• The bottom power socket is for PSU B.
An ON/OFF power switch for each supply is integrated into its AC connector on the rear
panel. The front panel of each power supply incorporates three status lamps, as shown:
AC (green): lit when AC power is ON
DC (green): lit when DC output is OK
FLT (red): lit when supply is faulty