GUIDE TO INSTALLATION AND OPERATION
26
| IRD-3802
IP Config
DHCP checkbox
The "DHCP" parameter activates or deactivates dynamic network addressing. When activated, it allows a
server to dynamically attribute an IP address and configuration information to the IRD-3802. When the
checkbox is selected, the static network parameters become unavailable.
IP Address
Mask
static network parameters
Gateway
Enter the values directly in the data boxes.
•
The user MUST PRESS
“
Enter”
on the computer keyboard to validate the values
Current IP Address / Current Mask / Current Gateway – these are the current values for this card.
Destination
Unicast Address
In unicast streaming, this is the address of the equipment to which the signal must be sent. This is only valid
when the Ethernet Port Direction is set to Output.
Port Number
This is the port on which the signal is present. This is valid for either transmitting or receiving. If this port does
not correspond to the source, no signal will be received.
Encapsulation
Select the IP protocol to use to stream packets.
•
RTP
•
UTP
Streaming Mode
Select Unicast or Multicast from the pulldown
Multicast Address
Enter the address to be used when Multicast is selected in the Streaming Mode pulldown
Note that the allowed IP first number range is 224 to 239
Forward Error Correction (FEC)
Forward Error Correction (FEC) is only available in RTP mode. This setting will allow inserting FEC codes
into the stream when the port is sending data. On reception, FEC is automatic.
Pro-MPEG FEC (D) pulldown: [OFF, 4, 5, 6,…., 19, 20]
Pro-MPEG FEC (L) pulldown: (only active when the one above is not OFF)