Miranda ADX-102i, Руководство по установке и эксплуатации, Страница: 19 / 25

13
•
ERR (Error)
The ERR LED will turn on if no serial digital 4:2:2 signal is input or if an
input error has been detected. Make sure the source signal is properly
connected to 4:2:2 IN and verify for any source equipment errors.
•
EDH (Error Detected Here)
This LED turns on to indicate a serial data transmission error has been
detected.
•
Test
This LED turns on to indicate that test signals are selected to the outputs.
•
Audio groups 1 to 4
These LEDs turns on to indicate which digital audio groups have been
detected in the 4:2:2 IN input signal.
•
LTC
This LED turns on to indicate that sampled LTC signal has been detected
in the
4:2:2 IN input signal.
•
DVITC
Reserved for future release.
3.4 Digital Audio Disembedding Selection
(
OUT-> A1-2 to A7-8)
AES/EBU digital audio pairs can be disembedded from any of four groups within
the selected ancillary data space of the 4:2:2 digital video signal (see section 3.10
for ancillary data space selection). Perform the following steps in order to select
the group to disembed for any of the 8 audio signal pairs:
1. Press SELECT to enter the menu. OUT is displayed.
2. Press SELECT to enable the audio group selection menu. The current audio
group from which to disembed the AES pair is displayed (GRP1 through
GRP4).
3. Press (+) or (-) to change the audio group selection. If you wish not to change
the audio group selection, select ESC.
4. Press SELECT to enable the AES digital audio source selection. The currently
selected source is displayed. Press (+) or (-) to change the audio source
selection.
5. Press SELECT to store the new audio group selection and return to OUT.
6. To return to normal mode, press ESC again