Mirabelle GALATIA MIRGA241, Руководство по установке

Страница: 2 / 24

BEFORE YOU BEGIN
• Carefully inspect the new toilet for damage.
• If the existing toilet does not have a supply
shut-off valve below the tank, install one
before installing the new toilet.
BEFORE YOU BEGIN
• Carefully inspect the new toilet for damage.
• If the existing toilet does not have a supply
shut-off valve below the tank, install one
before installing the new toilet.
1. REMOVE THE EXISTING TOILET
• Turn off water supply.
• Flush toilet, then sponge out all remaining
water from tank.
• Disconnect supply shut-off valve (if present),
and remove old tank and bowl.
TOOLS AND MATERIALS
10 “ Adjustable wrench
Supply shut-off valve
Tape measure
Level
Sponge
Wax seal
5/16” Bolts w/nuts and
washers
Putty knife
1/2” Nut driver/socket
Hacksaw
Screwdriver
CAUTION
Risk of personal injury or
product damage.
Handle with care. Vitreous china can break
or chip if the product is handled carelessly.
CAUTION
Risk of hazardous gases.
If the new toilet is not installed immediately,
temporarily stuff a rag in the closet flange.
2 1
• Remove old wax seal from floor with
a putty knife.
• Replace old bolts with the new 5/16”
diameter bolts.
Putty knife
Old wax seal
Flange
Flange
5/16” Diameter bolts
1
To ensure this product is installed properly, please read these instructions carefully before you begin.
(Certain installations may require professional help.) Also be sure your installation conforms to local
codes.
CAUTION: PRODUCT IS FRAGILE.
TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
REMOVE OLD TOILET
a. Close toilet supply valve and flush tank completely.
Towel or sponge remaining water from tank and bowl.
b. Disconnect and remove supply line.
NOTE: If replacing valve, first shut off main water supply!
c. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping
sewer gases.
d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: Mounting surface must be clean and level before new toilet is installed!
PARTS INCLUDED FOR INSTALLATION
4” Drain
Adapter
3” Drain
Adapter
Expansion
Bolts
Mounting
Bolts &
Washers