7
Mounting Bracket
InSTallaTIon
note!
For dry lined, stud partition, shower cubicle or laminated panel walls the installer
may wish to obtain alternative proprietary cavity fixings. Use of these alternative
fixings is beyond the scope of this guide.
read the section:
Installation requirements
before proceeding with the
installation.
the slide bar should be positioned to one side of the shower control at a convenient
height for all the family. It should be positioned so that the showerhead discharges
down the centre line of the bath, or across the opening of the shower cubicle. the
showerhead should be directed away from the shower control.
1.
Decide on a suitable position for the
slide bar avoiding buried cables and
pipes.
2.
Mark the wall fixing hole positions and
drill two holes to suit the wall fixings
and insert the wall plugs.
note!
For new installation optimum
fixing centres 600 mm. Replacement
installation fixing centres 620 mm
maximum.
3.
Install the wall plugs and mounting
brackets and secure with the screws.
check vertical alignment.
note!
the mounting brackets are
slotted to aid adjustment.
4.
Install the clamp bracket and the
slide bar supports onto the slide
bar.
note!
Some components may
already be pre-assembled.
5.
Fit the slide bar supports over the
mounting brackets. adjust the slide
bar vertically ensuring an equal
length of slide bar protrudes from the
top and bottom mounting bracket.
Slide Bar
Support
Slide Bar
clamp Bracket
