26
control lever handle
control lever
Bearing
lug
concealing Plate
Backplate
shroud screws
cutout
Grubscrew
Control Assembly (Built-in Models)
1.
Unscrew and remove the control lever handle.
2.
loosen the Grubscrew (by approximately 4 turns) and pull off the control lever
and Bearing.
3.
carefully unclip the concealing Plate from the Backplate.
note!
Use a screwdriver in the cutout to assist separation.
4.
align the slots in the Backplate with the lugs on the hub (refer to illustration),
and fit the Backplate to the Mixer.
5.
align the holes in the Backplate with the threaded holes on the Mixer and secure
with the two shroud screws (removed earlier).
note!
Make sure that the Foam seal is fully compressed.
Do not
overtighten
.
6.
With the cutout at the bottom, locate the concealing Plate over the Mixer,
engage the crosses in the concealing Plate with the square recesses in the
Backplate, and push firmly until the Concealing Plate clicks into position.
7.
With the lug in the 8 o’clock position fit the Bearing into the Concealing Plate.
8.
Make sure that the Hub is positioned fully clockwise and refit the Control Lever
with the Grubscrew at the bottom, retighten the Grubscrew and refit the Control
lever handle.
9.
Before using the shower, refer to section:
‘Commissioning’
.
align the hub with the
slots on the Backplate
Содержание Element Thermostatic Mixer
Страница 42: ...42 notes...
Страница 43: ...43 notes...
