12
1062243-W2-N
Determine the direction and route
of the incoming water supply:
falling (entering the shower from
the top), or rising (entering the
shower from the bottom).
Note: - DO NOT
use an incoming
supply entering the shower directly
from the back. Add an elbow to the
supply pipe and connect it as a
rising or falling supply.
Swivel the inlet connector assembly
to suit. Remove the inlet blanking
cap. Avoid trapping the green earth
bonding wire.
Warning! Turn off the electrical and water supplies before proceeding with
the installation of the shower. The electricity must be turned off at the mains
and the appropriate circuit fuse removed, if applicable.
Note: An installation template is supplied to help you install the shower.
Remove the three cover retaining
screws, the cover and the service
tunnel.
Caution! Handle the glass
cover assembly with care.
Installation of
Mira Azora
Wall fixings are not supplied. For solid wall structures a red rawl plug and a
no. 8 x 1½” countersunk brass or stainless steel screw should be used. For other
wall structures such as panels alternative fixings may be required. A minimum of 3
fixing screws should be used.
Note: - DO NOT use an
incoming supply entering the
shower directly from the back.
Add an elbow to the supply
pipe and connect it as a rising
or falling supply.
Cover
Cover Retaining
Screw
Inlet
Connector
Installation
