10
INSTALLATION
Warning!
Turn off the electrical and water supplies before proceeding with the
installation of the Mira Alero. The electricity must be turned off at the mains and
the appropriate circuit fuse removed, if applicable.
Note!
An installation template is supplied to help you install the Mira Alero.
Installation of Mira Alero
Wall fixings are not supplied. For solid wall structures a red rawl plug and a
no. 8 x 1½” countersunk brass or stainless steel screw should be used. For
other wall structures such as panels alternative fixings may be required. A
minimum of 3 fixing screws should be used.
Remove the three cover retaining
screws and the cover.
Caution!
Handle the glass cover
assembly with care.
Cover
Cover Retaining
Screw
Determine the direction and
route of the incoming water
supply: falling (entering the
shower from the top), or rising
(entering the shower from the
bottom).
Note! - DO NOT
use an
incoming supply entering the
shower directly from the back.
Add an elbow to the supply
pipe and connect it as a rising
or falling supply.
Swivel the inlet connector
assembly to suit. Remove
the inlet blanking cap. Avoid
trapping the green earth
bonding wire.
Inlet
Connector
