Minuteman E Ride 30, Руководство по обслуживанию

Страница: 61 / 80

9.2 Settings at the Accelerator Pedal
Before further setting of the drive potentiometer use a voltmeter to measure
at the drive control unit between X51 Pin 3 and Pin 9.
When the accelerator pedal is not pressed down, the voltage has to amount to
U
≈
0 V and increase continuously up to U
≈
6.5 V as the pedal is pressed down to
t I d t t f t ti th i i lt tt i d h stop. In order to guarantee a perfect operation, the minimum voltage attained when
pressing down the pedal has to be U = 4.5 V.
After the pedal has attained its limit position, the drive potentiometer must not
Positioned at a stop. A clearance of 2mm is required between the final position of the
Accelerator and the potentiometer stop (check at the adjusting lever of the ‘R1’
Accelerator and the potentiometer stop (check at the adjusting lever of the R1
potentiometer if required).
If the stop position of the drive potentiometer has already been attained with the
Accelerator pedal, the drive potentiometer may be turned in its oblong holes.
Irrespective of the pedal position, a voltage of approx. U
≈
10,5 V
applies between X51 Pin 3 and Pin 8.
61