Minuit Une IVL PHOTON, Руководство по обслуживанию

Страница: 32 / 63

IVL™ Photon Service Manual AA 32
6.3
Make sure that the rubber seal MT1-
001057 which is shown in the diagram
stays in its place on the fixture’s body,
under the tilt module.
Before putting back the module, you
need to check the TILT address (see
section
REP7 :)
When fixing back the module in its place,
make sure that it is resting on its fixation
point and that the seal is well positioned.
Plug back the connector, be careful of
the direction and of the seal.
Like shown on the diagram, an arrow is
here to indicate you the direction of the
connector (arrow=red wire).
Don’t forget the washer, and tighten
screws with a torque of 1.4 Nm.
After assembling back the fixture you
must do a full SW update (See section
SOF1:) and do a tilt calibration (see
section CAL2 :).