If you wish to use a tire size 26x1.0" or smaller, you
need to install the Z-shaped "Small Wheel Adapter"
between Base Plate and Mag unit to raise up the
roller height.
The direction of Z-adapter is fixed so follow the
arrow printed on the top and make sure it's pointing
toward the front (toward your bike).
If the drive roller cannot reach the tire even if you
install the adapter, make sure you have been installed
in correct direction.
Use the original cap head bolts for the Base Plate,
and use the supplied hex head bolts for the Mag unit.
How To Use Small Wheel Adapter
Hex Head Bolt
Cap Head Bolt
Z-Adapter
Required Tools:
1 x 10mm Spanner
1 x M4 Hex Wrench
- Page 8 -
Why My Remote Shifter Doesn't Work Properly?
(Fig. R)
Rubber Shim
If you have a shifting issue where you can't set the remote at L or H, your cable may be stretched.
To fix this problem, follow the adjust the cable tension.
1.
Set your remote shifter at "H" position and remove the shifter from your handlebar, then straighten the
cable as much as possible.
2.
Pull out the plastic cover cap on foot of the remote cable. (see Fig. P)
3.
Hold the inside adjusting screw and push it toward the shifter, then adjust the locking nut to set the cable
tension properly. (see Fig. Q)
4.
Install the cover cap again.
Adjusting Screw
Lock Nut
Cap
Tighten Nut
(Fig. P)
(Fig. Q)