How To Install Remote Shifter
!
If the rear tire has touched any other parts than the Drive Roller, that part may be
damaged and your tire will wear out quickly.
5.
To remove the bike from the V130M, loosen the micro adjust knob first, then loosen the Hub Handle.
If you remove the bike without changing the roller position, the next installation may become difficult
because the rear wheel has been pushed forward by the roller.
- Page 7 -
Required Tool:
1 x M4 Hex Wrench
Decrease
Increase
Hook
Lever
1
2
The V130M comes with a convenient remote shifter device.
By installing it on your handlebar or stem, you can adjust the
resistance in 7 different levels without getting off the bike.
The remote shifter should be used in conjunction with the gears
on your bike to achieve maximum efficiency in your workout.
How to install the remote shifter
1) Wrap the flexible plastic band around the handlebar,
2) Put the hook to the gutter on the plastic shifter base,
3) Flip up the lever to lock.
How to increase the resistance level
Twist the shifter lever toward "H" symbol.
How to reduce the resistance level
Twist the shifter lever toward "L" symbol.
!
"L" is not zero resistance. There is still some resistance
at "L" level due to the roller compression to the tire.
The remote shifter is pre-adjusted to fit the standard handlebar size;
22mm (7/8") diameter.
If it becomes loose or too tight, or you need to install the shifter onto
an oversized handlebar or stem, adjust the band length by turning the
plastic screw on the band with an M4 hex wrench (see Fig. N).
(Please be advised that the hex wrench doesn't come in the package)
!
The plastic band and screw are not made to be abused.
Do not over-tighten.
You should take off the hook before adjusting.
(Fig. L)
(Fig. M)
(Fig. N)
(Fig. O)
How To Adjust Resistance Level