If you wish to use a tire 26x1.0 or smaller, you'll
need to purchase and install the optional Z-shaped
"Small Wheel Adapter" between the Base Plate
and Mag unit to raise the height of the roller.
The direction of Z-adapter is fixed so follow
the arrow printed on the top and make sure it's
pointing toward the front (toward your bike).
If the drive roller cannot reach the tire even if you
install the adaptor, make sure you have installed
the adapter in the correct direction.
Use the original cap head bolts for the Base Plate,
and use the supplied hex head bolts for the Mag
unit.
How To Use Small Wheel Adaptor (Option)
Z-Adaptor
Required Tools:
1 x 10mm Spanner
1 x M5 Hex Wrench
- 7 -
Why Doesn't My Remote Shifter Work Correctly?
If setting the remote in the L or H position becomes
difficult, it may be due to the inner cable having too
much slack.
To fix this problem, follow the steps to adjust the
initial cable tension.
1.
Set your remote shifter at "H" position and
remove the shifter from your handlebar, then
straighten the cable as much as possible.
2.
Pull out the plastic cover cap on foot of the
remote cable. (see Fig. P and R)
3.
Hold the inside adjusting screw and push it
toward the shifter, then adjust the locking nut to
set the cable tension properly. (see Fig. S)
4.
Check if the shifter lever can travel between L
and H correctly, especially when shifting to L.
Install the cover cap again.
(Fig. Q)
(Fig. R)
(Fig. S)
(Fig. T)
Hex Head Bolt
Cap Head Bolt
Base Plate
