- 4 -
Parts List for LR961
Left Side Coupling Bolt
(for standard quick relaese skewer)
Lock Nut
Right Side Coupling
Hub Clamp Lever
Lever Cover
Roller Pressure Adjust Knob
Pivot Bolt
Flywheel
(becomes HOT after use)
Drive Roller
(Fig. D)
Lock Nut
Left Side Coupling Bolt
Hub Clamp Lever
(Fig. E)
(Fig. F)
(Fig. G)
(Fig. H)
How To Install Rear Wheel
1
2
3
Turn the Lock Nut counter-clockwise to
loosen. (see Fig. E)
Left Side Coupling is a screw bolt.
Turn it to adjust the length. (see Fig. F)
4
5
6
7
Raise the Hub Clamp Lever up to retract the
Right Side Coupling. (see Fig. F)
Insert the left side hub end of your wheel
(quick release lever side) into the left side
coupling cone. (see Fig. G)
In this position, place the other side
of the bike into the right side (rear cog
side) coupling cone.
Make sure your derailleur cable goes
OVER the coupling.
Now, push down (lower) the Hub Clamp
Lever until it fully engages the skewer or
axle nut. (Fig. G)
Make sure the Clamp Hub Lever is lowered into its locked position and cannot be lowered any
further.
The frame may appear slightly open but this is normal.
If the frame seems to be opened too widely, remove the bike, turn the Left Side Coupling Bolt
clockwise to retract a little, and mount your bike again.
Failure to do so could damage your bike and/or the trainer.
