© MINOTAIR Ventilation Inc. - www.minotair.com
35
(PENTACARE-V12-OWNER'S MANUAL-2019-Rev-014)
W
ALL
-M
OUNTING
•
The digital control consists of three main parts (A, B, C in Figure 24):
A.
The back piece,
B.
The electrical board and
C.
The snap-on cover.
•
Before mounting, you must disassemble the digital control. To do this, use your
fingers to lift one corner of the snap-on cover
C
until it comes off. Be careful not to
lose the small black plastic frame around the screen, and be sure to memorize its
position to facilitate reassembly later.
•
For wall-mounting, you must first affix the back-piece
A
in one of two ways:
1.
On an electrical box. In this case, use the corresponding rounded-head screws
(supplied) and make sure the electrical box is mounted horizontally, or
2.
Directly onto the wall. In this case, use the plastic pins (supplied), as required,
and the corresponding rounded-head screws (supplied).
•
Ensure the back-piece
A
is level.
•
Then proceed to connect the phone cable by passing it through the square
opening of the back-piece
A
and inserting the connector into the terminal of the
electric board
B
.
•
Rest the electrical board
B
on the back-piece
A
and fasten the parts together using
the flush-head screws (supplied) made for plastic.
•
Finally, put back the small black plastic frame around the screen, and fit the snap-
on cover
C
.
Figure 24
–
Wall-Mounting
