© Copyright
MINOS DIS TICARET LIMITED SIRKETI., 2017. All rights reserved. Reprinting, even of sections, only possible with the approval of
MINOS DIS TICARET LIMITED SIRKETI.
Document No: T-DYKM 1,5-2.2018_I.O.M./ Tarih: 09.07.2018
b. Reduce the total loading time
c. Reduce the mixer RPM to limit aggressiveness in processing
d. Modify the knife quantity or placement (See section 4.4)
Try to discharge the mixed ration within a short time after mixing. A fully
loaded mixer which is bounced over rough terrain or allowed to settle will
require more horsepower during start-up.
1. Position the mixer in a straight line with the tractor, to reduce the stress on
the PTO shaft.
2. Start the mixer and partially open the discharge cover.
3. Adjust the discharge unit height for the desired flow of feed.
4. After load begins to discharge, increase tractor RPM to full PTO to insure fast
and thorough cleanout.
Run tractor at 3/4 of rated tractor RPM (no more) while processing to help
reduce HP and/or spillage of hay.
Set hay stops to
"low" position
. (See section 4.5) This will reduce spillage due
to hay "piling" up near the hay stops.
If HP required to process and mix high percent amounts of
balage/grassy hay is too high, the following can be done:
1. The remaining knives can be laid-back to a less aggressive
"in"
position.
(See
section 4.4)
4.3.3- Step 3 (Discharging)
(only for implements driven by a P.T.O Shaft)
4.3.4- Other Mixing Recommendations
(only for implements driven by a P.T.O Shaft)
37
