Minolta magicolor 2300 Series, Руководство по обслуживанию

Страница: 115 / 144

115
(4) Service menu
(5) Network menu
• If the printer is connected and used on a network, the following settings should be speci-
fied.
• For details about each setting, contact your network administrator.
Page Count
A six-digit number indicating the number of pages that have been printed
until now with this printer is displayed.
Controller Ver. The controller firmware version is displayed.
Engine Ver. The printer engine firmware version is displayed.
DIMM Full Test
A complete DIMM test is performed, allowing you to check that there are no
errors in the DIMM.
SDRAM Full Test
A complete SDRAM test is performed, allowing you to check that there are
no errors in the SDRAM.
Power On Test
A Power On test is performed. Wait until the test is finished and “Ready” is
displayed.
User Default
The settings for Energy Saver, Auto Continue and Chaining Tray are
returned to their defaults.
The default settings are listed below.
Energy Saver: 30 minutes
Auto Continue: On
Chaining Tray: On
IP Address
Set the IP address of this printer on the network.
Using the
Up , Down , Prev. and Next keys, enter the value.
Subnet Mask
Set the subnet mask value of the network.
Using the
Up , Down , Prev. and Next keys, enter the value.
Gateway
If a router is used on the network, enter the IP address of the router.
Using the
Up , Down , Prev. and Next keys, enter the value.
HW Address
The Ethernet hardware address for this printer can be seen. (It cannot be
changed.)
HTTP This specifies whether or not PageScopeLight can be accessed.
SNMP This specifies the access privileges for the MIB file.
DHCP/BOOTP
DHCP: If there is a DHCP server on the network, set whether or not the IP
address is automatically assigned by the DHCP server and other network
information is loaded.
BOOTP: Set whether or not the IP address is automatically assigned by
BOOTP and other network information is loaded.
Either can be set to “On” or both can be set to “Off”.