37
3. Select shutter speed and aperture (p. 38).
4. Turn the appropriate manual-flash-control dial and select
the desired power level (p. 38).
• See the tables on page 38 to 43 for the aperture and power level
needed to obtain a proper exposure. The flash-ready lamp
will not
blink on the control panel after the photo is taken.
• The size of the step on the manual-flash-control dials can be changed
from full-stop increments to half-stop increments by adjusting the cus-
tom settings. See page 52.
When viewed from the rear
(control panel side), the
manual-flash-control dial for
twin flash A is on the left;
and that for twin flash B is
on the right. Any power level
setting between 1/1 ~ 1/64
can be selected.
The manual-flash-control dial for the
ring flash is on the left side (this is the
same control dial used for the twin
flash A). Select any power lever
between 1/1 ~ 1/64.
Manual Flash With Ring Flash
36
1. Select the M mode on the cam-
era.
2. Press the TTL/M/test button
(TTL/M/
/ ) until the M lamp
glows.
• Each time the button is pressed, the
flash modes will change as follows:
(For test flash firing see page 44.)
3. Select shutter speed and aperture (p. 38).
4. Turn manual-flash-control dial and select the desired
power level (p. 38).
TTLflash
Test flash
Manual flash
Test flash
TTLflash
Modeling flash
Manual flash
Modeling flash
TTL flash
Test flash
Manual flash
Test flash
Continued on next page
MANUAL FLASH (M)
A
B
For ring flash