MINN KOTA Riotide SP, Руководство пользователя

Страница: 15 / 26

AUDIO
AUDIO AUDIO
AUDIO
PATTERN PATTERN PATTERN PATTERN
WHAT CONDITION CAUSE IT WHAT CONDITION CAUSE IT WHAT CONDITION CAUSE IT WHAT CONDITION CAUSE IT
OCCURS IN OCCURS IN OCCURS IN OCCURS IN
WHICH AUDIO WHICH AUDIO WHICH AUDIO WHICH AUDIO
MODE
MODE MODE
MODE
2 second long
beep Every time the receiver is powered up an there are no remote
IDs learned.
All
1 chirp
When foot pedal is in the CON position all remote commands
from the remote will be ignored.
All
5 beeps Foot pedal speed control is moved while in remote mode. All
Steady tone Heard while holding down the learn button on the receiver. All
4 beeps After a remote button is pressed while the receiver learns it's ID. All
A ten second
long warbling
sound that
transitions into a
steady tone
Heard during the process used to clear all stored remote IDs.
After the learn switch is released, a 2 second long beep will be
heard.
All
1 long beep 2
short beeps,
pause, (repeat) Powered up with MOM/CON in the CON position (or mom switch
held). When the foot pedal is moved to momentary, the power
up audio will be heard.
All
COPILOT
TROUBLESHOOTING
15
CAUSE
CAUSE CAUSE
CAUSE EFFECT
EFFECT EFFECT
EFFECT SOLUTION
SOLUTION SOLUTION
SOLUTION
The battery is discharged Replace battery
Receiver may not have “learned” the ID
number of the remote.
Remote needs to be learned. See “
“ADDING/REMOVING REMOTES” section
to learn the remote ID number.
With the foot pedal connected, the MOM-
CON switch is in the CON position. An
audio response will be heard if a button is
pressed with the foot pedal in the CON
position.
The foot pedal switch must be placed in
the MOM position. The receiver will not
accept any commands from the remote
with the switch in the CON position
REMOTE IS NOT
TRANSMITTING
If remote has been taken apart, the
keypad and top case may have been
installed backwards. Take remote apart (BATTERY
REPLACEMENT SECTION) and reinstall
case halves with the proper orientation.
WHEN RECEIVER IS
POWERED UP, IT SOUNDS A
BEEP PATTERN. (1 long beep,
2 short beeps, pause, repeat)
The foot pedal MOM-CON switch is in the
CON position
The foot pedal switch must be placed in
the MOM position. The beeping sound will
continue until the switch is placed in the
MOM position
Prop speed is set at “0” Increase the prop speed above “0”
THE PROP IS NOT TURNING
BUT THE “PROP ON” AUDIO
TICK IS STILL GOING
Prop ON tick occurs only in Audio mode 3
Switch Audio mode to either Audio 1 or 2.
See “Audio Modes” section.