MINN KOTA Riotide SP, Руководство пользователя

Страница: 10 / 26

PROPELLER
REPLACEMENT
MAXIMIZER
TROUBLESHOOTING
10
PROPELLER REPLACEMENT:
• Disconnect motor from battery prior to
changing the propeller.
• Hold the propeller and loosen the anode/
nut with a wrench.
• Remove anode/nut and washer. If the
drive pin is sheared/broken, you will need
to hold the shaft steady with a screw-
driver blade pressed into the slot on the
end of the shaft.
• Turn the old prop to horizontal ( as illus-
trated ) and pull it straight off. If drive pin
falls out, push it back in.
• Align new propeller with drive pin.
• Install prop washer and anode/nut.
• Tighten anode/nut 1/4 turn past snug.
[25-35 inch lbs.] Be careful, over tighten-
ing can damage prop.
NOTE: The weedless wedge propeller is designed to provide
absolute weed free operation with very high efficiency. To
maintain top performance, the leading edge of the blades
must be kept smooth. If this edge is rough or nicked,
restore to smooth by sanding with fine sandpaper.
MOTOR TROUBLESHOOTING:
1. Motor fails to run or lacks power:
• Check battery connections for proper polarity.
• Make sure that the terminals are clean and corrosion free.
• Check the battery water level. Add water if needed.
2. Motor loses power after a short running time:
• Check battery/batteries charge, if low, restore to full charge.
3. Motor does not steer.
• Make sure the drive/depth collar is tight andfully engaged with the drive motor.
4. Motor does not respond to CoPilot commands.
• Make sure the cable connector plugs at the drive mount are secure.
5. Control head vibrates during normal operation:
• Remove and rotate the prop 180°. See removal instructions in prop section.
CAUTION: DISCONNECT THE
MOTOR FROM THE BATTERY
BEFORE BEGINNING ANY
PROP WORK OR MAINTE-
NANCE.
WEEDLESS
PROPELLER
DRIVE PIN
ANODE / NUT
WASHER
SLOT
MAXIMIZER™:
The built-In Maximizer’s electronics create pulse width modulation to provide longer running
time and extended battery life. With the Maximizer speed control, you may, in some appli-
cations, experience interference in your depth finder display. We recommend that you use
a separate deep cycle marine battery for your trolling motor and that you power the depth
finder from the starting / cranking battery. If problems still persist, call our service department
at 1-800-227-6433.