Page
20
of
34
4. Connecting Lights
The Wireless Effects Controller (WEC) can connect and control up to 400 Minleon RGB lights or
thousands of lights if grouped together using additional Minleon accessories.
Minleon RGB lights have a female plug at the end so additional RGB lights can be connected.
These can be any type of compatible Minleon RGB lights, for example you could have a string
of C9 RGB lights and then connect a string of C7 RGB lights to have two different types of lights
connected to the one WEC.
Always disconnect power before adding or removing lights
4.1
Power Considerations
The WEC will allow up to 125 Minleon RGB lights to be connected and controlled using the
Minleon 5-amp power supply. The controller is shipped with a 2-amp power supply that can
run a load of approximately 50 Minleon RGB lights.
When adding additional Minleon RGB lights then the power supply load must be taken into
consideration.
For every additional Minleon RGB light added then 0.035 amps of load must be added
You can buy additional power supplies and power injectors from local your Minleon
distributor in a range of sizes (refer to accessories section for available types).
4.1.1
Methods of Connecting Additional Power
There are 2 main ways to add additional power to control additional Minleon RGB Lights.
1.
Replace the current power supply with a larger power supply (maximum 5 amps)
2.
Add additional power supplies using the power injector lead.(refer to accessories
section)
Note:
It is important that the Minleon Power T and power cable be used for supplying
power down the line-not immediately after the WEC.
The +12VDC must never be connected between different power supplies.
Содержание WEC
Страница 1: ...Page 1 of 34...
