Minimizer 101358, Руководство по обслуживанию

Страница: 12 / 53

12
Seat Cushion Removal
(Figure 1)
- Lift up lever (1) and pull seat cushion to foremost position.
- Undo two screws (2) and remove tilt handle (3) from seat cushion (F).
- Lift up lever (1) and slide sideways towards (A) as shown in the picture below .
- Move seat cushion forwards until seat cushion releases on its own.
- Disconnect electrical feeders for seat cushion heater and ventilation, if necessary.
Seat Cushion Mounting:
- Bowden cable (8) must be positioned between lever (1) and seat cushion ground plate.
- Lay the keyholes (4) of the seat cushion (on the cushion’s b ottom side) onto the sliders
(7) at the rear.
- Push lever (1) upwards (don’t move cushion) and push lever in direction of arrow (B)
- Press down on the seat cushions while lining up the four key holes (5) onto the sliders
(7) at the front and back.
- Push the cushion in direction of backrest (till stop) while still pressing down on the
complete seat cushion till handle engages.
- Check now if all four sliders (7) are locked in the keyholes (4 & 5) (no vertical movement
allowed).
- Take note, that the cushion is now locked in horizontal and vertical direction.
Sliders for Seat Cushion:
- Dismantle seat cushion.
- Pull out plastic pin (6) and squeeze out slider (7).
Sliders Mounting:
- Mount sliders (7) at the seat frame.
-
Push in pin (6) (level of pin head (6) must be flat to fit the flat of the slider head (7), (see
Section C).