MiniMax FORMULA SP1, Эксплуатация и обслуживание

Страница: 29 / 49

ADJUSTMENTS
9.2
SP1
BCGB9 BCGB9
BCGB9 BCGB9 BCGB9
9-1 AUTOMATIC FEED AND CHANGE OF SPEED
To switch on the feed, turn lever (N fig.9.1a): carry out this operation with the machine running.
There are 4 feed speeds available: 5-8-12-18 m/min: there is an idle position between each other (feed standstill).
WARNING:
Never machine workpiece of length adn thbickness lower than the values permitted (L =
220 mm;
≠ ≠ ≠ ≠ ≠
3 mm), as in that case the system, which control the feed and the pressure on
the workpiece, can not operate and causes dangerous conditions.
9-2 THICKNESSING TABLE RAISING
WARNING: Before lifting the thicknessing table make sure that there are no wood residures on the
table, as in that case the system, which control the feed and the pressure on the workpiece,
can not operate and causes dangerous conditions.
To lift or lower the thicknessing table turn selector (M fig.9.1a) and the table will rapidly be displaced in the
direction indicated by the selector.
Reach the right position with micrometric table adjustment by pressing button (L ) which enables slow motion
adjustment only upwards.
Working measurement required must always be obtained by raising the table in order to take up slack between
screws and lead nut.
Read out the working measure on scale (A fig.9.1) and on decimal indicator (I fig.9.1a).
The 2 screws on the limiting rod serve as top end stops; with the table totally up you get a working height
corresponding to a piece thickness equal to 3 mm.
When the table is locked against the bottom/top mechanic stops or against the workpiece, the red pilot lamp
(ALARM) (L fig.9.1a) lights up and raising movement is blocked.
Reverse the feed direction by selector (M fig.9.1a) to reset the normal working conditions.
If the measure given by indicator (I fig.9.1a) does not correspond to the real thickness of the finished piece insert
a small screwdriver into hole (T fig. 9.1a), lightly press and turn clockwise to increase the decimal value of the
measure indicated; turn counterclockwise if you shall decrease this value.
9.1
A