MiniMax FORMULA SP1, Эксплуатация и обслуживание

Страница: 13 / 49

GENERAL
1.12
SP1
BC_GB1
1.7 SAFETY RULES
1- Carefully read this manual before starting the machine
2- Only trained operators should use the machine
3- Training must include information regarding dangers which may be encountered when using the machine and
the precautions to be taken
4- The operator must be trained regarding the correct use of guards and safety devices. Besides this the operator
must be trained to carry out periodical testing on guards and safety devices.
5- The operator must never leave the machine unattended when it is running
6- The machine has been built to afford the highest degree of safety as well as top performance.
7- The manufacturer will not be held responsible for any damages which may occur due to alterations made to
the machine by the user.
However final safety depends on you. Any machine tool can be potentially dangerous: do not forget it!
PERSONAL SAFETY
1- The operator must be provided with proper overalls e.g. double leather and synthetic material
overalls (not supplied by Mini Max) to protect him from wood splinters
2- Experience teaches that there are various objects on a person that can cause injuries; take off rings,
watches, bracelets; button your sleeves tightly around your wrists, take off ties that could be caught in
several places, tie hair back using caps, elastics or hair pins.
3- Always use glasses, or protective shields for your eyes
4- Use ear protection (ear phones, ear plugs etc.)
5- Use a mask to protect you from dust
MACHINE SAFETY
1- Be extremely careful when starting up any work cycle
2- Before raising thicknessing table, make sure that there are no wood particles on the table
3- Make sure that no parts are on the worktable which are not required
4- Never process workpieces which are too small or too large for the machine.
5- Knives which are not sharp reduce quality of finish and increase danager of kickback of workpieces.
6- Use tools in conformity with EN847-1 norms and suitable for manual feed.
7- Tool adjustment must be carried out when the machine is switched off and using the proper device
(e.g. gauge, comparator)