Then add in the front end also some drops
of JB weld into the tailboom just before the
front end of the cardboard.
Now push the cardboard into the boom
that the rear end of the cardboard is about
5mm (1/5“) before the slots are beginning.
Press the cardboard carefully on the tailb-
boom surface and remove resin rests in
the rear and the front end of the tailboom
as well.
Remove some anodized black surface
from the front end of the tailboom D639
(the side without slots) with a small flat file
to get a good grounding between tail and
mainframe. For this reason the front tail-
boom clamp is not anodized. Then push
the tailboom careful in the clamps. Be cau-
tious that you do not damage any servo
cable.
Pull the tailbelt 286 either with a long
cranked wire thru the boom or use a thin
rope with a weight at the end (f.e. a big
nut). Check that the belt is not turned in
anyway in the tailboom. Then put a finger
from above in the belt end...
