Minebea Intec PR 92/00N, Руководство по установке

Страница: 11 / 16

NOTICE
Welding or lightning strike current lowing through the cell can damage it.
All electrical welding on the weighing system must be inished before mounting the load
cells.
NOTICE
Corruption of measurement results!
The elastomer support must not be used to absorb transverse forces.
4.3.2 Installing the mounting kit and inserting the load cell
Note:
How to mount the vessel in the frame structure is described below.
If elastomer supports are used, they must be provided on all load cells.
The work steps must be carried out on all support points of the weighing object.
Procedure:
1. At the supporting point (elastomer support / vessel frame), make the borehole for the
elastomer support (1) in the vessel frame.
2. Mount the load cell (5) with spacer (4) on the lower mounting plate (3). The property
classes and tightening torques of the screws (2) must be observed (see Chapter 4.2 .
3. Screw in the elastomer support (1).
4. Mark the boreholes for the lower mounting plate (3) on the foundation and make the
holes.
5. Fix the mounting kit to the foundation. The property classes and tightening torques
of the screws must be observed; see Chapter 4.2 .
4 Installation Mounting kit with elastomer support PR 92/00N
Minebea Intec EN-9